Electro-Mechanical Assembler

03 May 2019
31 May 2019
Contract Type
Full Time
My client are a leading manufacturer of electro-mechanical sub-assemblies for a wide range of industries. Due to continued growth, they are looking to hire extra staff for the their production areas.

This is a full time temporary position initially for 8 week but could continue for a 12 week period following which could go permanent for the right person after 12 weeks

Job Responsibilities:

?? To perform a wide variety of electronic, electro-mechanical, mechanical or measurement product assembly operations on product components, assemblies or sub-assemblies.
?? To follow methods and sequence of operations in performing wiring, component installation, hand soldering, cable harnessing, welding and fitting on assembly units.
?? Makes setups and adjustments holding tolerances to blueprint specifications, Populating PCBAs with through hole components within pre-flow process while adhering to production documentation.
?? Component kit prep and PCB cropping within the pre-flow process. To set up equipment needed to assemble the printed circuit assemblies. i.e. ladder racks and assembly frames.
?? Reworking through-hole components post flow-solder. Hand soldering through-hole components within hand-assembly process.
?? Learn and perform basic troubleshooting protocols and rework for non-conforming units.
?? Ability to be flexible and handle priority changes as they occur. Meet expected daily production requirements.
?? To carry out normal assembly tasks as required.
?? Uphold the company's core values of Integrity, Innovation, Accountability, and Teamwork. Demonstrate behaviour consistent with the company's Code of Ethics and Conduct.

Ideally you will previous experience of assembling electronic assemblies, and preferably possess a high school diploma or equivalent trade school education. Minimum of 3 GCSEs grading A-C or equivalent level qualification. Knowledge of and demonstrated ability in the use of hand tools including soldering equipment, screwdrivers, wrenches, and heat guns is essential. Ideally IPC-A-610 certified.
Thorough understanding of workmanship standards and quality control procedures including compliance for ESD. Experience operating in a lean manufacturing environment. Comfortable with use of Microsoft Office Suite. Ideally previous electronics experience, with good manual dexterity.

Working 38 hours week Monday - Thursday 7.30 - 4.00pm with 30 minute lunch break and Friday 7.30 - 1.30.

If you are interested in this role, please apply below or call Kris Feaviour at Revision Recruitment